Your kitchen is set. Choose your doors and your floors.
This stage is optional and takes about a minute. The kitchen is already specified inside the Arc Elements system, so there is nothing to design here — the two things that change how the whole interior feels are the internal doors and the floor.
There are no prices on this page on purpose. Interiors are costed with your consultant once the plan is fixed, because the quantities depend on the final layout. What you pick here travels into your enquiry pack so that conversation starts from your taste, not a blank page.
Kitchen — as specified
Cabinetry, benchtop, sink and hardware are already set by the Arc Elements system. The colourway is the one lever, and it carries through the joinery, the doors and the trim.
—
Internal doors
All three are full-height flush leaves on the Arc jamb system. The difference is how the door meets the wall.
Floors
One floor through the whole plan reads calmest, and it is what we recommend.
What is not on this page, and why
Wall linings. Specified with your consultant once the plan is fixed, because the lining layout follows the module layout.
Quantities. Door counts and floor areas come off the final plan rather than an estimate you have to make here.
Pricing. Interiors are costed against those confirmed quantities, so a figure on this page would only ever be a guess.
Selections saved. One stage to go.
Your doors and floors are held with the rest of your configuration and appear in the pack you send. You will not re-enter any of it.
—
Continue to your enquiry pack
Four questions about your block — access, services, approvals, who installs — then everything you have configured goes through as one pack and a consultant picks it up.
Continue Back to stage 3Change the building first
Modules, widths, breezeway pairings and finishes. Your interior selections stay saved while you adjust the building around them.
Back to the configuratorNothing has been sent yet.